![]() ![]() Select your preferred Service or Service Group (in this case HTTP is selected).Insert your servers IP-address object as Destination.Provide a name to the Policy Control rule.Go to the Configuration → Security Policy → Policy Control menu and press the Add button to insert a rule. Note: NAT Loopback can be activated so internal clients can contact the server based on public info (WAN IP, DDNS hostname, Domain Name, etc.), only if Original IP is not set to ANY.Īs the final step, we need to create a Policy Control rule, to allow traffic to pass through to the server. In Original and Mapped Service select the service object you created for the port(s) that need to open.Select Service for the Port Mapping Type.Select the “WAN1_IP” object for Original IP.Choose the incoming interface (usually WAN1 or GE1).To create a Virtual Server rule go to, Configuration → Network → NAT menu. Specify start and end ports (if you only need one port such as the example above just specify the start port and the object will be created for a single port only).Specify protocol “TCP” or “UDP” (if you need both protocols you will need to add multiple service object, one using the TCP protocol and the other with UDP).If there isn’t a service object created for the port number(s) you need please click the Add button to insert a service rule. ![]() ZyWALL USG/VPN/ATP Series CLI Reference Guide. Zyxel USG40 97/533 Chapter 14 interfaces. You will be presented with a list of all the service objects on the device, both user created and predefined. Home / Zyxel / Security Firewalls / USG110 / CLI Reference Guide Page: 97. To create a service object for ports that are not predefined go to Configuration → Object → Service. Insert your server’s internal IP-address. Use the same step for the server’s address object. Choose “Interface IP” as Address Type, as this will dynamically follow the interface IP-address, and select Interface “WAN1” (GE2). To create an address object go to the Configuration menu. In this tutorial we will create two objects, one for the WAN1 (GE1) Interface IP-address and one for the server’s internal IP-address. To create a Virtual Server rule, the simplest way is to start with creating address objects. This guideline shows how to setup a Virtual Server rule. With Virtual Server (Port Forwarding) the ZyXEL gateway forwards specific requests to the selected server/client. Virtual Server (Port Forwarding) Rule(s) Setup for 4.XX Firmware version and higher
0 Comments
Leave a Reply. |